Weekly Calendar of Initial Equipment Training Sessions
Monday |
|||
| Facility Safety Training | 2:00 pm | Chad Eichfeld | N-203A MSC |
| Black Max MRL Annealing Training | 01:30 pm - 03:30 pm | Andy Fitzgerald | Cleanroom |
| AMAT Cluster Tool Training | 01:30 pm - 04:30 pm | Bill Drawl | Cleanroom |
Tuesday |
|||
| LPCVD 3 Stack Furnace Training | 09:00 am - 12:00 pm | Andy Fitzgerald | Cleanroom |
| Electroplating Training | 09:00 am - 10:00 am | Andy Fitzgerald | Cleanroom |
| Parylene Coater Training | 02:00 pm - 05:00 pm | Bangzhi Liu | Cleanroom |
| Wet Bench Training | 02:30 pm - 03:30 pm | Andy Fitzgerald | Cleanroom |
Wednesday |
|||
| Lithography Intro and Training on Litho Resist Stations, MA6 Contact Lithography & optical microscopes |
09:00 am - 11:00 am | Kathy Gehoski | MSC |
| PlasmaTherm 720 RIE Training | 10:00 am - 12:00 pm | Shane Miller | Cleanroom |
| Xactix XeF2 Etcher Training | 01:00 pm - 02:00 pm | Shane Miller | Cleanroom |
Thursday |
|||
| GCA8000/GCA8500 Stepper Training | 09:30 am - 12:00 pm | Kathy Gehoski | Cleanroom |
| Woollam Ellipsometer Training | 10:30 am - 11:30 am | Bangzhi Liu | Cleanroom |
| Alcatel Deep Silicon Reactive Ion Etch Training | 02:00 pm - 04:00 pm | Shane Miller | Cleanroom |
| Advanced Vacuum VIS320 DRIE Training | 02:00 pm - 4:00 pm | Cleanroom | |
To register for any of the below Session One trainings, please contact Jaime Reish at jdr15@psu.edu or by dialing +1.814.865.7348.To register for any of the above Session One trainings, please contact Jaime Reish at jdr15@psu.edu or by dialing +1.814.865.7348.
Facility Safety Training and Orientation
Facility Safety Training and Orientation is a requirement for any person who will be entering the Nanofab MSC cleanrooms.
Safety Training is held every Monday at 2:00 PM in room N-203A in the Millennium Science Complex. Safety Training will only occur when there are registered participants.
Individual Equipment Training
Session One, Two, & Three
NOTE: Trainees must attend a minimum of three successful training sessions for each piece of equipment. For most, all three sessions will take place within a 2-3 week period. Any user not completing all three sessions within the required timeframe may be requested to repeat trainings as deemed necessary.
